Measurement-computing Analyzer488 Manuel d'utilisateur télécharger pdf (Page 193)

Section 5 Analyst488 Software

5.5

5.7.3 Close

This command closes the active window. If two windows are open,

using Close will close the active window and make the previously inactive

window the new active window.

This command may also be selected without pulling down the File menu

by pressing

5.7.4 Virtual Front Panel

This command opens a window that gives you direct control over

the bus data and management lines. The control functions are separated

into logical areas for easy identification. The right and left cursor keys are

used to move between fields.

5.7.4.1 Source Control

The Talk/Listen state of the Analyzer488 may be changed

by pressing the

<T>

and

<L>

keys respectively while this field is

active. The

<up>

and

<down>

cursor keys may also be used to

change the state.

5.7.4.2 Message Entry

The state of the data lines may be set by entering a Bus or

ASCII message in this field followed by a

<CR>

. The state of the

data and ATN lines will be set automatically.

If this field is not active, this position displays the message

corresponding to the current state of the data lines.

5.7.4.3 Hexadecimal Data Entry

The state of the data lines may also be set by entering a

hexadecimal digit while this field is active. Valid digits are 0-9

and A-F. They are shifted in from the right when entered. Also,

the

<up>

and

<down>

cursor keys may be used to increment and

decrement this value.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 280 281

Commentaires sur ces manuels

Pas de commentaire

Measurement-computing Analyzer488 Manuel d'utilisateur Page 193

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Measurement-computing Analyzer488