Measurement-computing Analyzer488 Manuel d'utilisateur télécharger pdf (Page 176)

Section 4 Serial Controller

4.82

STERM

The

STERM

command sets the end-of-line terminators for output to the serial

host. All output from the Analyzer488 through the serial port is terminated by the

serial output terminator(s). All input from the serial host must be terminated by either

a Line Feed (LF) or Carriage Return (CR) except

OUTPUT

#count

During

INPUT

, the Analyzer488 takes the data it receives from the bus device

until it detects the LF or other optionally specified input terminator. It strips all CR

and LF from the input data and appends the serial output terminator(s) before sending

it to the serial host. The default serial terminators for output are factory set for

The query command

STERM?

returns the current serial output terminators.

TYPE System command

SYNTAX STERM[;]{[?]|term[term]|[NONE]}

term

is one of

$char

, or

, specifying a terminator

character.

RESPONSE None

MODE Any

BUS STATES None

QUERY Returns the string

STERM

followed by the current serial output

RESPONSE terminators.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 280 281

Pas de commentaire

Measurement-computing Analyzer488 Manuel d'utilisateur Page 176