Measurement-computing CB-7080 Manuel d'utilisateur télécharger pdf (Page 13)

CB-7080 & CB-7080D Counter/Timer User's Guide Application notes

1-9

Gate control setting

The gate control is ignored in frequency mode (51). The gate control is disabled in counter mode (50) by

default. To use a command to enable/disable the gate control:

 To use the $AAA0 command, the gate input must be low to enable the counter.

 To use the $AAA1 command, the gate input must be high to enable the counter.

 To use the $AAA2 command, the gate input is ignored. The counter is always enabled.

Preset value setting

The preset value is ignored in frequency mode (51). The counters go to their preset value in the first power-on

state. The reset counter command, $AA6N, also forces the counters to go to their preset value. The default

preset value is 0. Use the $AAPN(data) command to change the preset value. The key points include:

Table 1-5: Preset values

Factory default setting

Counter preset value is 0

Power on state

Counter 0/1 goes to preset value

$AA6N

Counter N goes to preset value

$AAPN(data)

Set preset value of counter N

Frequency input applications

The frequency mode type is indicated by entering 51in the command.

Table 1-6. Frequency mode settings

Command

Result - Frequency 0

Result - Frequency 1

$AAB0 to set input mode 0

$AA1H(data) and $AA1L(data)

Non-isolated channel 0 and

threshold value active

Non-isolated channel 1 and

threshold value active

$AAB1 to set input mode 1

$AA1H(data) & $AA1L(data)

Isolated channel 0

Isolated channel 1

$AAB2 to set input mode 2

$AA1H(data) & $AA1L(data)

Non-isolated channel 0 and

threshold value active

Isolated channel 1

$AAB3 to set input mode 3

$AA1H(data) & $AA1L(data)

Isolated channel 0

Non-isolated channel 1 and

threshold value active

To measure frequency:

1. Use the $AA1H(data) and $AA1L(data) commands to set the threshold value, if the frequency is in a

non-isolated input.

2. Use the $AAB? command to select the mode (this command will clear the current frequency first).

3. Use the #AA? command to perform frequency measurement.

Only four commands are important in frequency measurement mode:

$AAB?

Select mode

$AA1H(data)

Set high-level threshold value

$AA1L(data)

Set low-level threshold value

#AA?

Perform frequency measurement

The status-read-back commands are:

$AAB?

Mode read back

$AA1H

High_level threshold value read back

$AA1L(data)

Low_level threshold value read back

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Measurement-computing CB-7080 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Measurement-computing CB-7080