Measurement-computing CIO-DAC02/16 Manuel d'utilisateur

CIO-DAC02/16DUAL ANALOG OUTPUTSUser’s ManualRevision 5October, 2000

5 DATA REGISTERSThe CIO-DAC02/16 has four analog-output data registers. There are two for eachchannel, one for the lower eight bits and one for the

6 SPECIFICATIONSPOWER CONSUMPTIONNone- 12V SupplyNone+ 12V Supply400 mA Typical / 675 mA Max.+ 5V SupplyANALOG OUTPUTS40 mA Min ContinuousOutput Shor

For your notes.8

For your notes.9

For your notes.10

EC Declaration of ConformityWe, Measurement Computing Corporation, declare under sole responsibility that theproduct:DescriptionPart NumberCIO-DAC02/1

Measurement Computing Corporation16 Commerce Boulevard,Middleboro, Massachusetts 02346(508) 946-5100Fax: (508) 946-9500E-mail: info@measurementcomputi

MEGA-FIFO, the CIO prefix to data acquisition board model numbers, the PCM prefix to dataacquisition board model numbers, PCM-DAS08, PCM-D24C3, PCM-DA

Table of Contents76 SPECIFICATIONS ...65 DATA REGISTERS ...54 CONNECTOR DIAGRAM ...

This page is blank.

1 INTRODUCTIONThe CIO-DAC02/16 is a dual-channel analog output board having 16 bits ofresolution. One of six output voltage ranges can be individuall

3.1 BASE ADDRESSUnless there is already a board inyour system which uses address 300hex (768 decimal), leave the switchesas they are set at the facto

3.2 SIMULTANEOUS TRANSFER JUMPERAnalog outputs can be jumpered so that new output data for one (or both) DACs isheld in the registers until any regis

Use Switch bank S1 to select the output range of Channel 0.Use Switch bank S2 to select the output range of Channel 1.Table 3-2. Range Selection Swit

4 CONNECTOR DIAGRAMThe CIO-DAC02/16 signal connector isa 25-pin, D-type female connectoraccessible from the rear of the PCthrough the expansion backp