Measurement-computing WaveBook rev.5.3 Manuel d'utilisateur télécharger pdf (Page 140)

9-4 Fuse Replacement

989396 WaveBook User’s Manual

9. While wearing a grounded wrist strap, remove and replace the bad F201 fuse. Ensure that the new

fuse is fully seated.

10. Position the Rear Panel onto the WaveBook/516E chassis.

11. Thread the two #4-40 hex Jackscrews back into the EXPANSION CONTROL connector.

Tighten snug.

12. Thread the six #4-40 hex Jackscrews back into the EXPANSION PORT connectors.

Tighten snug.

13. Thread the two Rear Panel Side Screws and the Bottom Panel Screw and tighten snug.

14. Place the BNC Washer at the base of the EXPANSION SIGNAL IN BNC connector.

15. Place the BNC Nut over the EXPANSION SIGNAL IN BNC connector and thread by hand.

Using the wrench and 9/16” deep-well socket, tighten the BNC Nut snug.

16. Return the WaveBook/516E to normal service. Should any problems be noted, consult the factory.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 153 154

Pas de commentaire

Measurement-computing WaveBook rev.5.3 Manuel d'utilisateur Page 140