Measurement-computing WaveBook rev.5.3 Manuel d'utilisateur télécharger pdf (Page 138)

9-2 Fuse Replacement

989396 WaveBook User’s Manual

WaveBook/516A, /512A, and /516

Observe the Cautions and the important note on page 9-1 prior to beginning this

fuse replacement procedure.

1. If you have not already done so, turn OFF the power to, and UNPLUG the WaveBook and all

connected equipment. Remove all signal I/O lines from the unit.

2. Using a Phillips screwdriver, remove the four Cover Plate Screws from the left and right sides

of the unit. The following figure points out the screw locations.

3. Remove the Cover Plate [not shown].

F201

F201 Fuse Location in WaveBook/516A, /512A, /516

Cover Plate

Screw Locations

Cover Plate

Screw Locations

4. Locate the F201 fuse. It is located near the rear panel edge, close to the DIN5 POWER IN connector.

5. While wearing a grounded wrist strap, remove and replace the bad fuse. Ensure that the new fuse is

fully seated.

6. Replace the Cover Plate and secure it to the chassis with the 4 screws that were removed in step 2.

7. Return the WaveBook to normal service. Should any problems be noted, consult the factory.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 153 154

Pas de commentaire

Measurement-computing WaveBook rev.5.3 Manuel d'utilisateur Page 138