Measurement-computing Serial488A Manuel d'utilisateur télécharger pdf (Page 6)

1.4

Specifications

:$51,1*

Do not use this interface outdoors! The interface is intended for indoor use only! Outdoor

conditions could result in equipment failure, bodily injury or death!

:$51,1*

If equipment is used in any manner not specified in this manual, the protection provided by the

equipment may be impaired. Please read this manual carefully.

&$87,21

Do not connect AC line power directly to the Serial488A. Direct AC connection will damage the

equipment.

Serial488A

IEEE 488

&$87,21

The IEEE 488 terminal must only be used to control a non-isolated IEEE 488 system. The

common mode voltage (cable shell to earth) must be zero.

Terminal Installation Category:

Standard: Not Applicable CE: Category 1

Implementation: C1, C2, C3, C4 and C28 controller subsets.(Serial to IEEE)

SH1, AH1, T6, TE0, L4, LE0, SR1, RL0, PP0, DC1, DT0, E1.

Terminators: Selectable CR, LF, LF-CR and CR-LF with EOI.

Connector: Standard IEEE 488 connector with metric studs.

Serial Interface

Terminal Installation Category:

Standard: Not Applicable CE: Category 1

EIA RS-232C: AB, BA, BB, CA, CB

EIA RS-422A: Balanced voltage on TxD and RxD.

Character Set: Asynchronous bit serial.

Output Voltage: ±5 volts min (RS-422A). 5 volts typical (RS-232C).

Input Voltage: ±3 volts min.; ±15v max.

Baud Rate: Selectable 110, 300, 600, 1200, 1800, 2400, 3600, 4800, 7200,

9600, 19,200 and 57,600.

1 2 3 4 5 6 7 8 9 10 11 ... 84 85

Pas de commentaire

Measurement-computing Serial488A Manuel d'utilisateur Page 6