Measurement-computing LogBook Series Manuel d'utilisateur télécharger pdf (Page 188)

A-4 Supplement / HopNet Modems 887997 LogBook User’s Manual, Appendix A

Testing the LogBook and Modem Connectivity

In this section, steps are provided to:

• Verify the Parallel Port connectivity.

• Configure the LogBook’s Serial Connections. This configuration is done via Parallel Port

• Verify that the Serial Fixed Baud Rate functions correctly

• Use the HopNet Modems to connect the LogBook to the PC

Note: HopNet Modems are sometimes referred to as “serial extenders”

Verify “Parallel Port” Connectivity

The parallel port connection to the LogBook is used to configure all serial port connections. Thus this

verification is very important.

1. Physically connect the LogBook to the PC using the Parallel Port cable.

2. Launch LogView.

3. In LogView, open the DEVICE pull-down menu.

4. Click on the SELECT LOGBOOK option. A list of configured devices should display.

5. Select “LogBook Parallel.”

6. Click the <ATTACH> button.

Note that a successful connection is required to continue.

Configure the LogBook for “Serial Connections”

The following steps are performed to verify that the Serial Port can be used to connect the PC to the

LogBook.

1. Using the RS232 cable, physically connect the LogBook to the PC’s COM1 Port.

2. Launch LogView.

3. In LogView, open the DEVICE pull-down menu.

4. Click on the SELECT LOGBOOK option. A list of configured devices should display.

5. Select “LogBook Serial.”

6. Click the <ATTACH> button.

Note that a successful connection is required to continue.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 221 222

Pas de commentaire

Measurement-computing LogBook Series Manuel d'utilisateur Page 188