Measurement-computing DaqView Manuel d'utilisateur télécharger pdf (Page 23)

A Note about the Internal Clock Speed 100 kHz Prompt

At times [after selecting an expansion DBK] you may receive a message regarding “Internal Clock Speed.

The “Internal Clock Speed” information applies to devices that accept Analog I/O expansion. 200 kHz is

typically used.

In the Configure Systems

Hardware screen, after

selecting a DBK, you

might be prompted to

select an internal clock

speed of 100 kHz.

(See figure).

To select an “Internal Clock Speed” of 100 kHz:

(1) Select the Acquisition Setup tab on the DaqView main window.

On the lower left corner of the window, under Scan Configuration,

click the <Preferences> button.

The Preferences window will appear (following figure).

Note that the Preferences window can also be accessed from the

Windows pull-down menu.

(2) Under “Internal Clock Speed,”

select 100 kHz.

(3) Click the <OK> button to return to

the DaqView main window.

This completes the clock setting

procedure.

DaqView & ViewXL User’s Guide 886994 Configure System Hardware 3-7

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 85 86

Pas de commentaire

Measurement-computing DaqView Manuel d'utilisateur Page 23