Measurement-computing DaqView Manuel d'utilisateur télécharger pdf (Page 18)

The Configure System Hardware screen appears, showing the channel assignments.

Configure System Hardware Screen

The DBKs typically have a channel address set physically on the device, by either a

switch or a header. The channel designated in software must agree with the hardware

setting. Thus, in step 2 below, Channel 0 will only be used to select a specific DBK when

that DBK is physically set for Channel 0. Refer to the specific DBK section for more

information, if needed.

2. Under Analog I/O Option Cards External Connection, select the expansion down-arrow for the

chosen Daq Device channel, for example, P1 Channel 0. A “drop-down” will list the available

analog DBK options.

An alternative to using the expansion down-arrow to access the external connection drop-

down list, is to click within the text box. For example, in the following figure, after clicking

on P1 Channel 0’s “Direct Signal Connection” text, the drop-down list appeared.

Configure System Hardware Screen Showing Analog I/O Option Cards,

External Connection, P1 Channel Pull-down List for Channel 0

3-2 Configure System Hardware 886994 DaqView & ViewXL User’s Guide

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 85 86

Pas de commentaire

Measurement-computing DaqView Manuel d'utilisateur Page 18