Measurement-computing Daq PC-Card Manuel d'utilisateur télécharger pdf (Page 45)

Daq* Hardware DaqBook/260

DaqBook/DaqBoard/Daq PC-Card User’s Manual

1-14-00

3-15

12 – Install termination panels

Mount the termination panels to the card drawer with two screws for each panel.

13 – Install card drawer

The card drawer slides into the bottom track of the chassis.

Hold the card drawer by its handle and tilt it up slightly. Place it on the bottom track of the chassis.

Carefully slide the card drawer into the chassis. When it engages the bottom track, level the card drawer and

continue inserting it until it engages with the P1 interconnect board.

Tighten the three captive thumbscrews holding the termination panels to the chassis (see figure).

Install the two screws holding the card drawer to the chassis (see figure).

14 – Connect external signals

Connect signal inputs from sensors to termination panels.

15 – Install top cover

Slide on the top cover and install the two top cover screws (see figure).

16 – Turn on system power and check operation

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Pas de commentaire

Measurement-computing Daq PC-Card Manuel d'utilisateur Page 45