Measurement-computing Daq PC-Card Manuel d'utilisateur télécharger pdf (Page 17)

457-0942, rev 1.2

01-11-00

DaqBoard [ISA Type] Quick Start Guide 1-9

Turn power OFF to the PC and all attached equipment.

Remove the PC’s cover. Refer to your PC Owner’s Manual as needed.

Choose an empty 16-bit ISA slot. Loosen and remove the screw at the top of

the slot’s blank adapter plate. Then slide the plate up and out to remove.

Refer to your PC Owner’s Manual as needed.

Align DaqBoard’s edge-connector with the desired ISA slot, and with the

PC’s corresponding rear-panel slot. Gently press the board into the ISA slot.

Secure the board by inserting the rear-panel adapter-plate screw.

If using P2, P3, or both, route CA-60 cables as needed. Secure the P2 and

P3 rear panel connectors, as applicable.

Replace the computer’s cover.

Plug in all cords and cables.

Apply power to the PC.

DaqBoard’s I/O Connectors

If used, P2 and P3 require cable CA-60.

(3) Install Software

Remove previous version Daq* drivers, if present. You can do this through

Microsoft’s Add/Remove Programs feature by navigating from your

desktop as follows:

Start ⇒ Settings ⇒ Control Panel ⇒ Add/Remove Programs

Place the Data Acquisition Software CD in the host PC’s

CD-ROM drive.

Wait for PC to auto-access the CD.

This may take a few moments, depending on your PC.

If a Licensing Agreement appears, read over the agreement, then

click “Agree.” The Data Acquisition Software Master Setup Screen

appears (see figure at right).

Select

DaqBook/DaqBoard Support.

For Windows95/98/NT

(or more recent Windows), select

32-bit

If using Windows3.1, or DOS,

select

16-bit

instead of 32-bit.

If you do not have Acrobat Reader version 3.0 or greater installed

on your PC, select

Acrobat Reader

. This will enable you to read

and print documentation that is included on the install CD-ROM.

Select

DIAdem Post Acquisition DataAnalysis

Program.

Refer to your separate DIAdem

document (p/n 457-0903) for information

regarding this program.

Click “

Start Install

.”

Follow screen prompts.

(4) Test Hardware

Use the following steps to test your DaqBoard. Note that screen captures of the Daq

Configuration window (with DaqBoard Properties and Test Hardware tabs selected)

appear on the next page.

Run the

Daq Configuration

control panel applet.

Click “

Add Device

.”

Select your DaqBoard model from the “

Device Type

” scroll box and click

Select your DaqBoard from the “

Device Inventory

” window and click “

Properties

.”

Ensure settings are correct, and make changes if needed.

Select the “

Test Hardware”

tab.

Click the “

Resource Test

” button.

Click the “

Test

” button.

Test results should be displayed within a few seconds. Note that test results have two

components:

Resource Tests

and

Performance Tests.

Each is described on the

following page.

Note:

Testing the DaqBoard device may, in some cases, cause the system to hang. If test results are not

displayed in 30 seconds or the system does not seem to be responding, reboot the system. Upon

power-up, re-enter the Daq Configuration and change DaqBoard configuration settings to those that

work properly.

Device Inventory and

Device Type Windows

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Commentaires sur ces manuels

Pas de commentaire

Measurement-computing Daq PC-Card Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Measurement-computing Daq PC-Card