Measurement-computing ZonicBook Rev.3.0 Manuel d'utilisateur télécharger pdf (Page 27)

ZonicBook

11-01-01

Getting Started, pg. 23

Starting the ZonicBook

The ZonicBook system is ready for use once the tasks in the following checklist have been completed.

❑

Software Installed (pg. 3)

❑

Channel DIP-switches Set (pg. 4)

❑

Hardware Connected and Powered ON (pg. 5)

❑

Drivers Installed (pg. 6)

❑

Signal Lines Connected to ZonicBook BNC Connectors for Channel Input

❑

Unused BNC Connectors Capped

To start the ZonicBook system:

On the Start Menu, select Programs.

Select ZonicBook.

Select the applicable ZonicBook software, e.g., eZ-Analyst, eZ-Balance.

Reference Note: Refer to the applicable document module in regard to software specifics.

1 2 ... 22 23 24 25 26 27 28

Pas de commentaire

Measurement-computing ZonicBook Rev.3.0 Manuel d'utilisateur Page 27