Measurement-computing ZonicBook Rev.3.0 Manuel d'utilisateur télécharger pdf (Page 10)

Getting Started, pg. 6

11-01-01

ZonicBook

Installing ZonicBook Drivers

Only install the drivers that apply to your operating system.

To avoid installing the wrong driver, be sure to use the instructions that are intended for

your PC’s Windows system. Refer to the following sections as applicable.

➣

Windows XP (pg.6)

➣

Windows 2000 (pg. 10)

➣

Windows Me (pg. 14)

➣

Windows95/98 (pg. 17)

➣

Windows/NT (pg. 21)

Note: If you have previously installed ZonicBook drivers, you should not need to do so again,

even if you are upgrading your software.

Windows XP Users

Prior to installing the drivers, be sure that your ZonicBook system is

properly connected and powered.

Insert the DSP-Card into your computer’s PCMCIA slot 0.

Windows XP will start the Hardware Wizard.

After the dialog box appears, verify that “Install from a list or specific location” is selected.

See following figure.

Click <Next>. A new dialog box will appear (following figure).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

Measurement-computing ZonicBook Rev.3.0 Manuel d'utilisateur Page 10