
Chapter 4
Specifications
All specifications are subject to change without notice.
Typical for 25°C unless otherwise specified.
Specifications in italic text are guaranteed by design.
Counter
Table 1. Counter specifications
Parameter Specification
4 (each with a corresponding Input, Gate, and Output)
Totalize, Pulse width, Period, Timing
Mode options Non-Recycle, Range Limit, Clear on Read, Up/Down,
Clear|Reload, Direction Control, Gate, Count trigger; mode dependent
Up to 64-bits (software-selectable)
16 steps from 500 ns to 25.5 ms; positive or negative edge sensitive; glitch detect
mode or debounce mode; software-selectable.
96 MHz (24 MHz – 30 ppm with a 4x DLL (delay-locked loop))
Internal or external scan pacer up to 4 MHz
Period/pulse width resolution
20.83 ns; 208.3 ns; 2.083 µs; or 20.83 µs
Input type (C0IN to C3IN and
C0GT to C3GT)
Schmitt trigger, 47 kΩ pull-down to ground with 33 Ω in series
Schmitt trigger hysteresis (C0IN to
C3IN and C0GT to C3GT)
0.4 V min
1.2 V max
Input high voltage threshold (C0IN
to C3IN and C0GT to C3GT)
1.3 V min
Input high voltage limit (C0IN to
C3IN and C0GT to C3GT)
Input low voltage threshold (C0IN
to C3IN and C0GT to C3GT)
0.6 V min
Input low voltage limit (C0IN to
C3IN and C0GT to C3GT)
–0.5 V absolute min
0 V recommended min
4.4 V min (IOH = –50 µA)
3.76 V min (IOH = –24 mA)
0.44 V max (IOL = 24 mA)
24 mA max per pin, constrained to 240 mA across all output pins (counter outputs,
timer outputs, digital outputs, pacer clock output, and +VO)
19
Commentaires sur ces manuels