Measurement-computing USB-CTR04 Manuel d'utilisateur télécharger pdf (Page 16)

USB-CTR04 User's Guide Functional Details

Pull-up/pull-down jumper

Figure 12. Pull-up/down jumper location

The pull-up/down jumper is configured by default for pull-down (see Figure 13).

Pull-down (factory default)

Pull-up

Figure 13. Pull-up/down jumper configurations

To pull the digital inputs high (5 V), configure the jumper for pull-up.

Proper LED alignment

When placing the circuit board within the housing, align the board LEDs with the top of the housing before

attaching the housing bottom.

Timer output

You can use TMR0 through TMR3 as 32-bit timer outputs. Each timer can generate a programmable width pulse

with a software-selectable frequency in the range of 0.022 Hz to 48 MHz. At higher frequencies, the timer

output frequency and duty cycle depend on the load impedance and the supply.

The timer output rate and pulse width can be updated asynchronously at any time, however, doing so results in a

pulse stream that is not seamless.

The following timer output options are software-selectable:

 pulse frequency

 duty cycle (pulse width divided by the pulse period)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Pas de commentaire

Measurement-computing USB-CTR04 Manuel d'utilisateur Page 16