Measurement-computing StrainBook/616 Manuel d'utilisateur télécharger pdf (Page 54)

5-4 Setup and Connecting to the Ethernet 947191 StrainBook/616 User’s Manual

STEP 1 – Install the Software

Install the software prior to connecting the StrainBook/616 to the Ethernet. If you have not already

installed the software, do so at this time. Refer to the section entitled Software Installation, page 5-2.

STEP 2 – Determine the type of Network Connection

To properly connect and configure a StrainBook/616, you must determine the type of network that the

device will become part of. This is because the type of network used has a direct bearing on the IP address

of the device.

The four network types are as follows:

Dedicated Network - with a direct cable connection from the PC to the device

Dedicated Network - making use of a network hub or switch

LAN with a DHCP server

(Local Area Network with a Dynamic Host Configuration Protocol)

LAN without a DHCP server

(Local Area Network with no Dynamic Host Configuration Protocol)

Brief descriptions and illustrations follow.

Dedicated Network - with a direct cable connection from the PC to the device

In this scenario a StrainBook/616 is connected directly to an Ethernet jack on a host computer.

Dedicated Network using a Direct Cable Connection

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 145 146

Pas de commentaire

Measurement-computing StrainBook/616 Manuel d'utilisateur Page 54