Measurement-computing PCI-DIO48H Manuel d'utilisateur télécharger pdf (Page 14)

PCI-DIO48H User's Guide Functional Details

Pull-up and pull-down resistors

The PCI-DIO48H has open locations where you can install a 2.2 K , eight-resistor single inline package (SIP)

resistor network for each port. The locations are labeled PORT 1A, PORT 1B , PORT 1C (RN10 to RN12), and

PORT 2A, PORT 2B, and PORT 2C (RN13 to RN15).

The SIP is made up of eight 2.2 K resistors. One side of each resistor is connected to a single common point and

brought out to a pin. The common line is marked with a dot or line at one end of the SIP. The remaining resistor

ends are brought out to the other eight pins (refer to Figure 4).

2.2 KOhm SIP

Dot

(LO or HI)

I/O Lines

Figure 4. Eight-resistor SIP schematic

The SIP may be installed as pull-up or pull-down. At each RN# location, there are 10 holes in a line. One end of

the line is +5V, the other end is GND. They are marked HI and LO respectively. The eight holes in the middle

are connected to the eight lines of a port.

 For a pull-up function, mount the SIP with the common pin (marked with a dot or line) in the HI position.

 For a pull-down function, mount the SIP with the common pin in the LO position.

When installing pull-up and pull-down resistor SIP packs, we recommend using a 2.2 K, eight-resistor SIP

(MCC part number SP-K2.29C).

Unconnected inputs float

Unconnected inputs typically float high, but not reliably. If you are using a PCI-DIO48H for input and have

unconnected inputs, ignore the data from those lines. You do not have to terminate input lines. Unconnected

lines will not affect the performance of connected lines. Mask out any unconnected bits in software.

Replacing a fuse

The PCI-DIO48H has a 1 amp slow blow fuse connected to the +5V User Output at pin 49, and is labeled F1 on

the board. A spare fuse is installed on the board at location F2. Each fuse is secured to the board with clips for

convenient replacement.

A fuse will blow during operation if amperage exceeds 1 amp. If you need to replace a fuse, perform the

following procedure.

1. Pry the center of the fuse from the fuse holder clip.

2. Insert the replacement fuse into the fuse holder clip.

Fuse specifications

Refer to the information below to purchase additional fuses, (or an equivalent), if required:

 Manufacturer: LittelFuse

 Series: 452 Series - NANO

2®

Slo-Blo

Subminiature Surface Mount Fuse

 Part number: 0452001. (Include the period as part of the item number.)

 1 amp, 125 volts, 0.225 Ω

 www.littelfuse.com/part/0452001.html

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Measurement-computing PCI-DIO48H Manuel d'utilisateur Page 14