Measurement-computing Parallel488 Manuel d'utilisateur télécharger pdf (Page 41)

Section 5 IEEE 488 Primer

5.9

5.7.8 Selected Device Clear (SDC)

This causes a single device to be initialized to a pre-defined or power up state. ($04)

5.7.9 Serial Poll Disable (SPD)

The SPD command disables all devices from sending their Serial Poll status byte. ($19)

5.7.10 Serial Poll Enable (SPE)

A device which is Addressed to Talk will output its Serial Poll status byte after SPE is sent and

ATN is unasserted. ($18)

5.7.11 Group Execute Trigger (GET)

This command usually signals a group of devices to begin executing a triggered action. This

allows actions of different devices to begin simultaneously. ($08)

5.7.12 Take Control (TCT)

This command passes bus control responsibilities from the current Controller to another device

which has the ability to control. ($09)

5.7.13 Secondary Command Group (SCG)

These are any one of the 32 possible commands (0 to 31) in this group. They must

immediately follow a talk or listen address. ($60 to $7F)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 50 51

Pas de commentaire

Measurement-computing Parallel488 Manuel d'utilisateur Page 41