Measurement-computing eZ-PostView rev.2.0 Manuel d'utilisateur télécharger pdf (Page 72)

3-14 Menus 979595 eZ-Analyst

Window Menu > Delete Window

Deletes the window that is currently in focus. When multiple plot windows are open, one is

always the “focus window. When a window does not have focus, its title bar is dimmed. To

change the “focus window,” simply click on top or side border of the window of interest.

Window Menu

> Input Channels

The Input Channels window is selected from the eZ-Analyst Windows pull-down menu. This

Window only applies to eZ-Analyst.

Buttons

When selected, “Buttons” removes the channel button boxes from the toolbar and displays

them in a floating window. The buttons are used in the exact same manner as when they were

located on eZ-Analyst’s main window. Removing the checkmark from “Buttons” places the

channel buttons back onto the toolbar. Note that the <Input Channel Buttons> button [located

on the toolbar, just to the left of where the channel buttons reside] provides the same

functionality. See chapter 5 for location.

• To add a channel: use the mouse to click and drag a channel box from the

complete channel button display into the plot area.

• To remove a channel: use the mouse to click and drag a channel box (from the

right-side of the plot) into the plot area.

Status

The Status dialog box (following figure) uses a chart to indicate the followings:

• Volts linear

• percent of the Full-Scale Voltage (FSV)

The status box includes “maximum” bars to show the highest level of signal value reached by

each channel during the measurement process.

Status

Meas V

Measured Voltage

+/- FSV The Full-Scale Voltage

Delta % The percentage difference between the measured voltage

and the Full-Scale voltage, such that Meas V is n% of FSV;

with n being the value of Delta %.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 143 144

Pas de commentaire

Measurement-computing eZ-PostView rev.2.0 Manuel d'utilisateur Page 72