Measurement-computing eZ-PostView rev.2.0 Manuel d'utilisateur télécharger pdf (Page 30)

eZ-PostView

08-30-022

Interactive Plot Display 3-5

Changing the Display Range

To change the maximum or minimum range value: Left-click on upper or lower scale value that is to be changed, then

enter the new value. An example follows.

To change the X-Axis: Hold down the <Ctrl> key, at the same time, left-click and drag the mouse cursor horizontally on

the plot. Two vertical cursor lines will define the new x-axis end points.

To change the Y-Axis: Hold down the <Alt> key, at the same time, left-click and drag the mouse cursor vertically on the

plot. Two horizontal cursor lines will define the new Y-axis end-points.

To simultaneously change the X & Y Axes: Hold down the <Ctrl> and <Alt> keys, at the same time, left-click and drag

the mouse cursor diagonally on the plot. A rectangle will define the new area of the plot.

In this example, the cursor and PC

keyboard were used to change the

maximum scale value from 3.000 volts

to 3.800 volts.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 143 144

Pas de commentaire

Measurement-computing eZ-PostView rev.2.0 Manuel d'utilisateur Page 30