Measurement-computing DataShuttle Manuel d'utilisateur télécharger pdf (Page 13)

DataShuttle and DynaRes

11-13-01

Introduction & Installation of the DataShuttle 1-5

DataShuttle-RTD

The DataShuttle RTD models are specifically designed for high accuracy RTD measurements. The DS-16-

8-RTD-115e version is suited for –200°C to 115°C measurements, and the DS-18-8-RTD-750C version is

suited for –200

C to 750

°C measurements. Both have signal conditioning set resistors pre-installed at the

factory for use with two or three wire RTDs. This model also features terminals for 8 digital I/O lines, with

room for up to 8 optically isolated modules. Two analog outputs are available on the –AO models: DS-16-

8-RTD-115C-AO and DS-16-8-RTD-750C-AO.

The DataShuttle-RTD can also measure non-RTD inputs. For channels that are required to measure other

signals, remove the pre-installed resistors at R3 and R4. See example in the Analog Auxiliary Components

section of Chapter 2 for a more detailed illustration.

Illustration of the DataShuttle-GP and DataShuttle-RTD

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 125 126

Pas de commentaire

Measurement-computing DataShuttle Manuel d'utilisateur Page 13