Measurement-computing CIO-QUAD0x Manuel d'utilisateur télécharger pdf (Page 9)

2.4 TESTING THE INSTALLATION

2.4.1 InstaCAL

Run the

Insta

Cal program to test your board. Select the "Test" function of InstaCAL. This will run an internal test to assure

the base address has been properly set and the onboard registers are performing as expected. If the test fails, try

reconfiguring the board with a different Base Address. Once the board has been tested, select

FILE

then

Exit

, and the

configuration file will be written to your hard disk.

2.4.2 QUAD Encoder Demo Software

Included with your CIO-QUAD board is a floppy disk labeled QUAD ENCODER DEMO SOFTWARE. This disk contains

a demo program that allows you use many of the features of the CIO-QUAD without writing any code.

To install the demo software, insert the disk and run the SETUP.EXE program. Once installed, just double click the icon in

the QUADENC program group to run the program. You will be prompted to enter the board type and the base address you

selected above. Click OK after entering the appropriate values.

The main program screen allows to select the channels you wish to read and many configuration options for those channels.

3 CIO-QUAD CONNECTOR DIAGRAM

Pin assignments for both differential and single-ended connections are shown in Figure 3-1 below.

Be sure to properly

phase the encoder according to the manufacturer’s instructions.

Viewed from above

Figure 3-1. Connector Pin Outs for CIO-QUAD04

Phase A- 1

+5V 2

Phase B- 3

+5V 4

Index- 5

6 Phase A+

7 Phase B+

8 GND

9 Index+

Differential

S ingle-Ended

GND 1

+5V 2

GND 3

+5V 4

GND 5

6 Phase A+

7 Phase B+

8 Ground

9 Index+

Viewed from the outs ide of the computer looking into the connectors on the board

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Measurement-computing CIO-QUAD0x Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Measurement-computing CIO-QUAD0x