Measurement-computing CB-7000 Utilities Manuel d'utilisateur télécharger pdf (Page 23)

2. Make the desired change(s).

2.Click on the “Setting” button.

3.The 7000 Utility displays the window as Figure 2-22. If the message “Please connect Init* to

GND. Then Click OK button again!!!” is displayed, connect Init* terminal to the GND terminal.

Setting Configuration OK !!

Please Turn off the power of 7000 module,

then Turn On again to take effect the setting!!!

Figure 2-22. Setting Configuration OK!!

4. Turn OFF the power to this module and then turn it back ON. If an Error Code 17 message is

displayed, it means a failure. Re-check the connection of INIT and GND of the module, and

repeat the above steps again.

2.7.9 Exiting the 7000 Utility

Please refer to Figure 2-23 to quit the 7000 Utility.

Figure 2-23. To Exit the 7000 Utility.

When exiting the 7000 Utility, a window will prompt you to exit as in Figure 2-24.

Figure 2-24. Make sure to exit 7000.

Please click “

Yes”

to exit the 7000 Utility.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Pas de commentaire

Measurement-computing CB-7000 Utilities Manuel d'utilisateur Page 23