Measurement-computing CIO-PDISO8 Manuel d'utilisateur télécharger pdf (Page 9)

CIO-PDISO8 User's Guide Installing the CIO-PDISO8

Unpacking the board

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the CIO-PDISO8 from its packaging, ground yourself using a wrist strap or by

simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If any components are missing or damaged, notify Measurement Computing Corporation immediately by

phone, fax, or e-mail:

 Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

 Fax: 508-946-9500 to the attention of Tech Support

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data

Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf.

Configuring the CIO-PDISO8

The CIO-PDISO8 has one base address switch, one input filter switch, and one wait state jumper which you

must set before installing the board in your computer . The InstaCal calibration and test program included with

the CIO-PDISO8 will show you how to set the switches. Run InstaCal before you open your computer and

install the board. The CIO-PDISO8 is shipped with the factory-default settings listed below.

Factory-configured default settings

Switch/jumper

Default setting

Base address switches

300h (768 decimal)

Input Filter Select switches

Wait State jumper

OFF position

Figure 1. Switch and jumper locations

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Pas de commentaire

Measurement-computing CIO-PDISO8 Manuel d'utilisateur Page 9