Measurement-computing CIO-PDISO8 Manuel d'utilisateur télécharger pdf (Page 12)

CIO-PDISO8 User's Guide Installing the CIO-PDISO8

Connecting the board for I/O operations

Connectors, cables – main I/O connector

The table below lists the board connectors, applicable cables and compatible accessory boards.

Board connectors, cables, accessory equipment

I/O connector type

37-pin D connector

Compatible cables

C37FF-x, where x = length in feet

C37FFS-x, where x =5 or 10 feet

Compatible accessory products

(with the C37FFS-x and C37FF-x cables)

CIO-MINI37

SCB-37

Information on signal connections

General information regarding signal connection and configuration is available in the Guide to Signal

Connections. This document is available on our web site at www.mccdaq.com/signals/signals.pdf.

Pin out – main I/O connector

Figure 5. Main I/O connector pin out

Caution! High voltages are present on the CIO-PDISO8 when you have connected high voltage inputs or

outputs to the CIO-PDISO8 connector. Use extreme caution! Never handle the CIO-PDISO8 when

signals are connected to the board through the connector.

Never remove the protective plates from the CIO-PDISO8.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Measurement-computing CIO-PDISO8 Manuel d'utilisateur Page 12