Measurement-computing 6K-SSR-RACK08 Manuel d'utilisateur télécharger pdf (Page 18)

6K-SSR-RACK08 User's Guide Installing the 6K-SSR-RACK08

Figure 2-4. 6K-SSR-RACK08 board jumpers and external power connectors

Power source

Set the power source with jumper JP1 (labeled POWER IN). You can power the 6K-SSR-RACK08 using one of

the following sources.

 the 6000 Series control board’s internal +5 V power supply (default)

 your computer’s +5 V power supply, or external +5 V supply (power cable supplied)

 AC adapter (supplied)

Figure 2-5

Figure 2-5. Power source jumper JP1 configurations

shows the

POWER IN jumper configured for each power source.

+5BD

Internal power

from the MCC board

External power from

the computer’s power supply

+5PC

External power from

an AC adapter

9V EXT

Internal power

from the MCC board

External power from

the computer’s power supply

External power from

an AC adapter

External +5 V PC power connections

You can power the 6K-SSR-RACK08 with your computer’s +5 V power supply using the

C-PCPOWER-10

cord that was shipped with the board. Each end of the cable has a keyed MOLEX type connector. To connect to

your computer’s internal power connectors, do the following:

Turn off power to the computer and remove the cover.

Connect one end of the C-PCPOWER10 power cord to one of your computer’s internal power connectors.

If necessary, refer to your computer's user manual for the location of the power supply connectors.

2-9

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Pas de commentaire

Measurement-computing 6K-SSR-RACK08 Manuel d'utilisateur Page 18