DBK60 3-Slot Expansion Chassis with Termination Panels Overview …… 1 Hardware Setup …… 2 1 – Turn off system power and disconnect DBK60 …… 3 2
The front panel has a male DB37 connector that leads to the acquisition processor via a CA-37-x, CA-37-xT, or equivalent cable. The rear panel is ma
1 – Turn off system power and disconnect the DBK60 If the DBK60 is presently connected in a system, turn off all system devices and disconnect the DBK
6 – Configure the chassis for the power source Use one power source, and only one power source, for cards on the P1 bus! +5 V is selected with the DB
7 – Install a power card, if needed If you determined [in step 5] that additional power is needed, add a DBK32A or DBK33 power card to the acquisition
DBK60, pg. 6 989594 DBK Option Cards and Modules 12 – Install the card drawer A. Hold the card drawer by its handle and tilt it up slightly. Plac
Commentaires sur ces manuels