Measurement-computing DAQFlex User Guide Manuel d'utilisateur télécharger pdf (Page 95)

DAQFlex Software User's Guide FlexTest Utility

The Ai Self Calibration window opens.

3. Click the Start button to start calibrating the analog inputs.

The progress bar updates as the operation progresses. When calibration is done the window

displays Complete.

4. Click OK to close the window.

Calibrating analog outputs

To calibrate a device's analog outputs, do the following:

1. Select the AO tab.

2. Click the Calibrate button.

The Ao Self Calibration window opens.

3. Click the Start button to start calibrating the analog outputs.

The progress bar updates as the operation progresses. When calibration is done the window

displays Complete.

4. Click OK to close the window.

DAQFlex message reference

Refer to the DAQFlex Message Reference chapter on page 31 for the supported DAQFlex API messages.

Note: FlexTest cannot be run at the same time as the DAQFlex Firmware Loader utility

(DAQFlexFWLoader.exe).

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 124 125

Pas de commentaire

Measurement-computing DAQFlex User Guide Manuel d'utilisateur Page 95