Measurement-computing USB-4302 Manuel d'utilisateur télécharger pdf (Page 15)

USB-4302 User's Guide Functional Details

Signal connections

Counter input, gate, and output

The counter pins (CTR1IN to CTR5IN, CTR1GATE to CTR5GATE, and CTR1OUT to CTR5OUT) provide the

connections for the clock input signal and gate signal to each counter, and the output signal from each counter.

The clock, gate, and output sources are software-selectable. You can configure each counter to count up or

down.

Digital input and output (DIn, DOn)

You can connect up to eight digital input lines to pins DI0 to DI7 (pin 22 through 29), and up to eight digital

output lines to pins DO0 to DO7 (pin 3 through 10).

You can use the digital input pins to detect the state of any TTL level input. Refer to the schematic shown in

Figure 6. When the switch is set to the +5V input, DI7 reads TRUE (1). If you move the switch to GND, DI7

reads FALSE (0).

+5V

GND

Figure 6. Schematic showing switch detection by digital channel DI7

For more information on digital signal connections

For more information on digital signal connections and digital I/O techniques, refer to the Guide to Signal

Connections (available on our web site at www.mccdaq.com/signals/signals.pdf).

Digital input pull-up/down configuration (DI CTL)

All digital input pins are floating by default. When inputs are floating, the state of unwired inputs is undefined

—they may read high or low. You can use the DI CTL connection (pin 21) to configure the inputs to read a high

or low value when they aren’t wired.

 To pull up the digital input pins to +5 V — inputs read high when unwired — wire the DI CTL pin to the

+5V pin (pin 20).

 To pull down the digital input pins to ground — inputs read low when unwired — wire the DI CTL pin to

the GND pin (pin 11).

The DI CTL connection pulls the inputs to +5V or GND through a 47 k Ω resistor.

Interrupt input (INT)

You can configure the interrupt input connector (pin 1) with InstaCal to trigger off rising or falling edge inputs.

You can program this pin to perform the following tasks:

 Send an event notification to the computer. The transfer rate is system-dependent.

 Latch the digital inputs. With this option, the current value of the digital inputs (0 or 1) is read and stored.

The stored value is updated when an active edge occurs on this pin.

 Latch the digital outputs. With this option, digital outputs are not set to the value written until an active

edge occurs on this pin.

 Save the current value of a counter. You can configure this option for each counter individually.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Measurement-computing USB-4302 Manuel d'utilisateur Page 15