Measurement-computing USB-201-OEM Manuel d'utilisateur télécharger pdf (Page 10)

USB-201-OEM User's Guide Functional Details

Connector W3

Header connector W3 provides connections for the analog inputs and the analog ground reference.

W3 pin descriptions

Pin Signal name Pin description Pin Signal name Pin description

1 CH0 Channel 0 2 AGND Analog ground

3 CH1 Channel 1 4 AGND Analog ground

5 CH2 Channel 2 6 AGND Analog ground

7 CH3 Channel 3 8 AGND Analog ground

9 CH4 Channel 4 10 AGND Analog ground

11 CH5 Channel 5 12 AGND Analog ground

13 CH6 Channel 6 14 AGND Analog ground

15 CH7 Channel 7 16 AGND Analog ground

Figure 4. Connector W3 pinout

Screw terminal connectors

Screw terminals J1 through J8 are unpopulated. When populated the screw terminals provide alternative

connections to the header connectors. Refer to the Specifications chapter for screw terminal pinouts.

USB connector

The USB connector provides +5 V power and communication. No external power supply is required.

LED indicators

The device has two LED indicators – Status and Activity.

 The

Status LED turns on when the device is detected and installed on the computer.

 The

Activity LED blinks when data is transferred, and is off otherwise.

Refer to Figure 2 on page 9 for the location of these LEDs.

Signal connections

Analog input

You can connect up to 8 single-ended inputs to screw terminals CH0 to CH7. The input voltage range is ±10 V.

Single-ended mode requires two wires; connect one wire to the signal you want to measure (

CHx), and connect

a second wire to the analog ground reference (

AGND).

External pacer I/O

The USB-201-OEM provides one external clock input (AICKI) and one clock output (AICKO) for the analog

input pacer. You can connect an external clock signal to

AICKI.

When using the internal clock,

AICKO outputs the ADC sample clock.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Pas de commentaire

Measurement-computing USB-201-OEM Manuel d'utilisateur Page 10