Measurement-computing SWITCH AND SENSE 8/8 Manuel d'utilisateur télécharger pdf (Page 11)

Switch & Sense 8/8 User's Guide Installing the Switch & Sense 8/8

2-3

If the STATUS LED turns off

If the STATUS LED is lit but then turns off, the computer has lost communication with the Switch & Sense 8/8.

To restore communication, disconnect the USB cable from the computer, and then reconnect it. This should

restore communication, and the LED should turn back on.

If you are running Windows XP and connect the Switch & Sense 8/8 to a USB 1.1 port, a balloon displays the

message "

Your USB device can perform faster if you connect to a USB 2.0 port." You can ignore this

message. The Switch & Sense 8/8 will function properly when connected to a USB 1.1 port

Caution! Do not disconnect any device from the USB port while the computer is communicating with the

Switch & Sense 8/8, or you may lose data and/or your ability to communicate with the Switch &

Sense 8/8.

If your system does not detect the Switch & Sense 8/8

If a "

USB device not recognized" message appears when you connect the Switch & Sense 8/8, do the

following.

1. Unplug the USB cable from the Switch & Sense 8/8.

2. Unplug the external power cord from the power connector labeled

7.5-20Vdc on the back of the Switch &

Sense 8/8.

3. Plug the external power cord back into the power connector.

4. Plug the USB cable back into the Switch & Sense 8/8.

Your system should now properly detect the Switch & Sense 8/8 hardware. Contact technical support if your

system still does not detect the Switch & Sense 8/8.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Measurement-computing SWITCH AND SENSE 8/8 Manuel d'utilisateur Page 11