Measurement-computing PointScan Road Map rev.2.0 Manuel d'utilisateur télécharger pdf (Page 18)

Remote I/O Configuration, General Tab

(e) Fill in the “Define RS-485 Communications for this Station” fields in the RS-485 tab, then click

<Next>. See following figure.

Information in the following figure [Remote I/O Configuration, RS-485 tab] refers to the RS-485 port

on the “RS-485 connected” module.

Protocol -

- For a /100 Series Module: Select <ModBus ASCII Slave>

- For a /200 Series module: Select <Modbus ASCII>.

Baud Rate - Needs to match the baud rate of the RS-485 link on the “Ethernet-

connected” /100 series module to which it is connected.

Mode, Lead Time, Lag Time - Accept the defaults. Click <Help> for more information.

Remote I/O Configuration, RS-485 Tab

14 878395 PointScan Road Map

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Pas de commentaire

Measurement-computing PointScan Road Map rev.2.0 Manuel d'utilisateur Page 18