Measurement-computing PCIM-DAS16JR/16 Manuel d'utilisateur télécharger pdf (Page 10)

PCIM-DAS16JR/16 User's Guide Installing the PCIM-DAS16JR/16

Optional components

If you ordered any of the following products with your board, they should be included with your shipment.

! Cables

C37FF-x

C37FFS-x

! Signal termination and conditioning accessories

MCC provides signal termination products for use with the PCIM-DAS16JR/16. Refer to the "Field wiring,

signal termination and signal conditioning" section on page 2-7 for a complete list of compatible accessory

products.

Unpacking the PCIM-DAS16JR/16

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the PCIM-DAS1602/16 from its packaging, ground yourself using a wrist strap or

by simply touching the computer chassis or other grounded object to eliminate any stored static charge.

If any components are missing or damaged, notify Measurement Computing Corporation immediately by

phone, fax, or e-mail:

! Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

! Fax: 508-946-9500 to the attention of Tech Support

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data

Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf.

Configuring the PCIM-DAS16JR/16

The PCIM-DAS16JR/16 board has one switch and two jumpers mounted on it. Before installing the PCIM-

DAS16JR/16 in the computer, verify that the board is configured with the settings that you want. Factory

default settings are listed in T . able 2-1

Table 2-1. Switch/jumper factory-configured defaults

Board label Switch/jumper description Default setting

S1 Channel mode switch 8 channel (diff)

P8 A/D Trigger edge jumper Rising edge

P2 Clock frequency jumper 1 MHz

The locations of each switch and jumper are shown in . Figure 2-1

2-2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Pas de commentaire

Measurement-computing PCIM-DAS16JR/16 Manuel d'utilisateur Page 10