Measurement-computing Micro488/p Manuel d'utilisateur télécharger pdf (Page 19)

Command Descriptions

09-27-02

3-1

Command Descriptions

3.1 Introduction

This section contains detailed descriptions of each of the low and high-level

commands available for the Micro488/p. There are two types of commands: bus

commands and system commands. Bus commands communicate with the IEEE 488

bus. System commands configure or request information from the Micro488/p.

Bus Commands:

A (ABORT I/O)

C (DEVICE CLEAR)

C;<addr> (DEVICE CLEAR w/device specified)

EO;n (EOI ENABLE/DISABLE)

EN (ENTER)

EN;<addr> (ENTER w/device specified)

L (LOCAL)

L;<addr> (LOCAL w/device specified)

LL (LOCAL LOCKOUT)

O;cmd$ (OUTPUT)

OA;<addr>;cmd$ (OUTPUT w/device specified )

RE (REMOTE)

RE;<addr> (REMOTE w/device specified)

RS (RESUME)

SP;<addr>; (SERIAL POLL)

SQ (SRQ CHECK)

TR (TRIGGER)

TR;<addr> (TRIGGER w/device specified)

/A (LOW-LEVEL COMMAND)

/L;<addr> (SEND LISTEN ADDRESS w/device specified)

/ML (LOW-LEVEL COMMAND)

/MT (LOW-LEVEL COMMAND)

/T;<addr> (SEND TALK ADDRESS w/device specified)

/UL (LOW-LEVEL COMMAND)

/UT (LOW-LEVEL COMMAND)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Pas de commentaire

Measurement-computing Micro488/p Manuel d'utilisateur Page 19