Measurement-computing eZ-TOMAS rev.11.0 Manuel d'utilisateur télécharger pdf (Page 54)

Changing Display Ranges and ScalesTo change the maximum or minimum range value (following figure): Left-click on

upper or lower scale value that is to be changed, then enter the new value. An example follows. This technique works for

both X and Y axis.

In this example, the cursor and PC

keyboard were used to change the

maximum scale value from 3.000 volts

to 3.800 volts.

To change the X-Axis (following figures): Hold down the <Ctrl> key, at the same time, left-click and drag the mouse

cursor horizontally on the plot. Two vertical cursor lines will define the new x-axis end points.

To change the Y-Axis (following figures): Hold down the <Alt> key, at the same time, left-click and drag the mouse

cursor vertically on the plot. Two horizontal cursor lines will define the new Y-axis end-points.

To simultaneously change the X & Y Axes (following figures): Hold down the <Ctrl> and <Alt> keys, at the same time,

left-click and drag the mouse cursor diagonally on the plot. A rectangle will define the new area of the plot.

5-4 Display Menu … Plots 947294 eZ-TOMAS

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 93 94

Pas de commentaire

Measurement-computing eZ-TOMAS rev.11.0 Manuel d'utilisateur Page 54