Measurement-computing Extender488 Manuel d'utilisateur télécharger pdf (Page 29)

Section 3 IEEE 488 Primer

3-9

3.7.8 Selected Device Clear (SDC)

This causes a single device to be initialized to a pre-defined or power up state. ($04)

3.7.9 Serial Poll Disable (SPD)

The SPD command disables all devices from sending their Serial Poll status byte. ($19)

3.7.10 Serial Poll Enable (SPE)

A device which is Addressed to Talk will output its Serial Poll status byte after SPE is sent and

ATN is unasserted. ($18)

3.7.11 Group Execute Trigger (GET)

This command usually signals a group of devices to begin executing a triggered action. This

allows actions of different devices to begin simultaneously. ($08)

3.7.12 Take Control (TCT)

This command passes bus control responsibilities from the current Controller to another

device which has the ability to control. ($09)

3.7.13 Secondary Command Group (SCG)

These are any one of the 32 possible c ommands (0 t o 31) in this group. They must

immediately follow a talk or listen address. ($60 to $7F)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 38 39

Pas de commentaire

Measurement-computing Extender488 Manuel d'utilisateur Page 29