Measurement-computing DBK Part 2 Manuel d'utilisateur télécharger pdf (Page 131)

Selecting an Excitation Voltage

Each channel has a voltage select header, which consists of 5 pairs of pins and a jumper. The jumper

position determines the excitation voltage. Possible voltages are 5, 10, 15, and 24 VDC. A fifth possibility

exists for a custom voltage that resides within the range of 5 to 20 V. To obtain a custom voltage you must

install a resistor in the excitation line labeled “PGM.” The method is discussed shortly.

Reference for Selecting a Pre-Set Voltage Value

The discharge of static electricity can damage some electronic components.

Semiconductor devices are especially susceptible to ESD damage. You should

always handle components carefully, and you should never touch connector pins or

circuit components unless you are following ESD guidelines in an appropriate ESD-

controlled area. Such guidelines include the use of properly grounded mats and

wrist straps, ESD bags and cartons, and related procedures.

WARNING

HOT COMPONENTS! Allow the DBK65 module to cool for at least 30 minutes

before removing the top cover. Some internal components can become very hot

and may cause burns.

To select a pre-set voltage (5, 10, 15, or 24V):

1. Remove the DBK65 from power and disconnect all signal lines.

2. Allow the unit to cool for at least 30 minutes.

3. Remove the 4 screws from the top cover plate. Then remove the plate.

4. Position the voltage select header’s jumper to the desired setting. See the preceding figure.

5. Re-install the top cover plate and secure it with the 4 screws that were removed in step 3.

DBK Option Cards and Modules 988793 DBK65 pg. 3

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 305 306

Pas de commentaire

Measurement-computing DBK Part 2 Manuel d'utilisateur Page 131