Measurement-computing DASYLab Manuel d'utilisateur télécharger pdf (Page 37)

DasyLab - Standard Driver 989693 Configuring DASYLab for WaveBook A-1

Appendix A Configuring DASYLab for WaveBook

Standard DASYLab Driver (DaqBoard/DaqBook/WaveBook/TempBook)

IOtech WaveBook users now have two choices of DASYLab drivers. These are:

Standard DASYLab Driver (DaqBoard/DaqBook/WaveBook/TempBook)

Enhanced DASYLab Driver (with multiple WaveBook and WBK40/41 support)

You should use the Enhanced DASYLab Driver if:

• You wish to run multiple WaveBook systems concurrently.

• You are using WBK40/41 modules in your system.

You should use the Standard DASYLab Driver if:

• You have already created DASYLab Worksheets for your system and you do not plan to use WBK40/41

modules or multiple WaveBooks in your system.

• You require optimal throughput performance while using a single WaveBook system.

If neither of the above scenarios applies, then either driver can be used for your WaveBook DASYLab application.

Note: You can download the latest hardware and DASYLab drives from our web site at www.iotech.com

Reference Notes:

Users of the Enhanced DASYLab Driver refer to chapter 1.

Users of the Standard DASYLab Driver refer to this Appendix.

Install DASYLab …… A-2

Install Low-Level Hardware Driver …… A-3

Select the Driver …… A-4

Configure the Hardware …… A-5

Putting Modules on the Worksheet …… A-8

Working with the WaveBooks

and WBK Options …… A-8

WaveBook …… A-9

WBK14 …… A-8

WBK15 …… A-9

WBK16 …… A-11

WBK17 …… A-12

WBK18 …… A-13

WBK40 …… (refer to chapter 2)

WBK41 …… (refer to chapter 2)

FIFO Settings (for WBK30 Option) …… A-15

General Experiment Setup …… A-17

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Pas de commentaire

Measurement-computing DASYLab Manuel d'utilisateur Page 37