Measurement-computing DaqTemp Manuel d'utilisateur télécharger pdf (Page 35)

DaqTemp Series User’s Manual

08-27-02

CE-Compliance 5-5

Connect the CA-195CE Cable to the Board

1. Connect one end of the CA-195CE Cable to DaqBoard/2000 Series Board’s

P4 connector. Note that either end of the cable can be connected to the

board; however, the white locator triangles must align with each other.

2. Align the Cable Clamp (1033-2009) with the

CE ORB and secure the items with two

4-40 x 3/16 screws (provided).

Note: In the right hand figure, the cable is not shown to

allow for greater clarity of parts.

Secure the Grounding Pigtail to Cable CA-195CE

Using Cable Clamps 1033-2009, 1033-2010, and two 4-40 x 5/16 screws, secure the Grounding Pigtail to

the cable. Note that the Clamps must be positioned over the cable’s Copper Band as indicated in the first

figure on this page. Tighten screws snug, but do not over tighten.

Note: In the following figure, the cable is not shown to allow for greater clarity of parts.

DaqTemp Module

DaqTemp PCI Board

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Pas de commentaire

Measurement-computing DaqTemp Manuel d'utilisateur Page 35