Measurement-computing CIO-DAS16/Jr Manuel d'utilisateur télécharger pdf (Page 11)

CIO-DAS16/Jr User's Guide Installing the CIO-DAS16/Jr

Installing the CIO-DAS16/Jr

After configuring the board, install the CIO-DAS16/Jr into your computer. Follow the steps below.

Install the MCC DAQ software before you install your board

The driver needed to run your board is installed with the MCC DAQ software. Therefore, you need to install the

MCC DAQ software before you install your board. Refer to the Quick Start Guide for instructions on installing

the software.

Turn your computer off, open it up, and insert your board into an available ISA slot.

Close your computer and turn it on.

To test your installation and configure your board, run the InstaCal utility you installed in the previous

section. Refer to the Quick Start Guide that came with your board www.mccdaq.com/PDFmanuals/DAQ-

Software-Quick-Start.pdf for information on how to initially set up and load InstaCal.

Connecting the board for I/O operations

Connectors, cables – main I/O connector

The table below lists the board connector, applicable cables, and compatible accessory products.

Board connector, cables, and accessory equipment

Connector type 37-pin male "D" connector

Compatible cables C37FF-x

C37FFS-x

C-EXP2DAS16-10

DFCON-37 (D-connector, D-shell, and termination pins to construct your

own cable)

Compatible accessory products with the

C37FF-x cable or C37FFS-x cable

CIO-MINI37

CIO-TERMINAL

CIO-SSH16

ISO-RACK16

Compatible accessory products with the

C-EXP2DAS16-10 cable

CIO-EXP16

CIO-EXP32

Pinout – main I/O connector

The CIO-DAS16/Jr analog connector is a 37-pin D type connector accessible from the rear of the PC through

the expansion backplate ( ). With the exception of the missing D/A signals, the signals available are

identical to the DAS-16.

Figure 6

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Measurement-computing CIO-DAS16/Jr Manuel d'utilisateur Page 11