Measurement-computing CIO-DAS08/JR/16 Manuel d'utilisateur télécharger pdf (Page 7)

4 CALIBRATION AND TEST

The board is supplied with software for calibration and test. You will find it in the InstaCal program under the CALIBRATE option.

Follow the instructions to guide you through the calibration sequence.

5 SIGNAL CONNECTIONS

The I/O connector is a 37-pin, D-type connector accessible from the rear of the PC through the expansion backplate.

The connector accepts female 37-pin, D-type connectors, such as on the C37FF-2, a 2-foot cable with connectors. For quick and easy

access to the board, use CIO-MINI37 screw terminal board.

Figure 5-1. I/O Signal Connector - CIO-DAS08/JR/16-AO

NOTE: Pins 18 and 19 (Analog Out 0 and Analog Out 1) are not used in the CIO-DAS08/JR/16 board version.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Measurement-computing CIO-DAS08/JR/16 Manuel d'utilisateur Page 7