Measurement-computing PC104-DAC06 Manuel d'utilisateur télécharger pdf (Page 8)

Figure 3-2 shows the jumper block in each configuration. Place the jumper on the two

pins closest to the word XFER for simultaneous transfer.

Figure 3-2. Simultaneous Transfer Jumpers

Jumper # DAC Controlled

J1 DAC 0 & 1

J2 DAC 2 & 3

J3 DAC 4 & 5

3.3 ANALOG OUTPUT RANGE JUMPER

The analog output voltage range of each channel can be set via a six pin jumper block.

The switches are located on the board near the DACs they control and are labeled S1

through S6. The number corresponds to the DAC under control + 1.

Set the jumpers for an individual channel using Figure 3-3 to orient the jumper block

pin 1, and Table 3-2 below to select the range.

Figure 3-3. Range Jumpers

XFR XFR

Shown for individual

transfers per channel.

Shown for simultaneous transfer

of both channels.

SIMULTANEOUS TRANSFER JUMPERS - One per pair of channels.

Position of S# relative

to pin1 for S1-S4

Position of S# relative

to pin 1 for S5 & S6

JUMPERS SHOWN +/-5v RANGE

531

642

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Measurement-computing PC104-DAC06 Manuel d'utilisateur Page 8