Measurement-computing CIO-DAC08 Manuel d'utilisateur télécharger pdf (Page 14)

CIO-DAC08 User's Guide Installing the CIO-DAC08

The analog outputs of the CIO-DAC08 are two-wire hook-ups. Always use low-level ground (LLGND) as the

ground reference for all analog hook-ups.

Cabling

The red stripe

identifies pin # 1

Figure 7. C37FF-x cable

Figure 8. C37FFS-x cable

Field wiring, signal termination, and conditioning

You can use the following cabling, screw termination, and signal conditioning products with the CIO-DAC08.

 CIO-MINI37 – 37-pin screw terminal board. Details on this product are available at

www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=102&pf_id=255

 CIO-TERMINAL – 37-pin screw terminal board with on-board prototyping area. Details on this product

are available on our web site at www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=102&pf_id=282

 DFCON37 – Connector kit that includes a 37-pin female D-connector, D-shell, 37 crimp pins, and cable

termination kit to construct your own cable. Details on this product are available on our web site at

www.mccdaq.com/cbicatalog/cbiproduct.asp?dept_id=103&pf_id=304

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Measurement-computing CIO-DAC08 Manuel d'utilisateur Page 14