Measurement-computing 200 Series DaqBook Manuel d'utilisateur télécharger pdf (Page 16)

2-4 Setup and Startup

01-23-02

DaqBook User’s Manual

If connecting your DaqBook to a notebook PC,

you can use a WBK20A, PCMCIA Interface Card.

Refer to separate instructions (supplied with the

WBK20A) if applicable.

If connecting your DaqBook to a desktop PC (with no

available EPP port), you can use a WBK21 Interface

card. Refer to separate instructions (supplied with the

WBK21) if applicable.

Reference Note: It is possible to use a VDC power source other than an AC-to-DC adapter.

Both the DBK Basics document module (included in this manual) and the DBK Option Cards

and Modules User’s Manual contain power-related information. The DBK manual is installed

on your hard drive during software installation. The default location is the Programs directory.

(4) Install Software and Product Support Documentation

Data Acquisition Software, Master Setup Screen

(a)

Remove previous version Daq device drivers, if present. You can do this through Microsoft’s

Add/Remove Programs feature by navigating from your desktop as follows:

Start

⇒

Settings

⇒

Control Panel

⇒

Add/Remove Programs

(b)

Place the Data Acquisition CD into the CD-ROM drive. Wait for PC to auto-start the CD. This may

take a few moments, depending on your PC. If the CD does not auto-start, use the Desktop’s Start,

Run, Browse feature.

(c)

If a Licensing Agreement appears, read over the agreement, then click “Agree.” The Data Acquisition

Software Master Setup Screen appears (see previous figure).

WBK20A Interface Card

BK21 Interface Card

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 53 54

Pas de commentaire

Measurement-computing 200 Series DaqBook Manuel d'utilisateur Page 16