Measurement-computing USB-4301 Manuel d'utilisateur télécharger pdf (Page 10)

USB-4301 User's Guide Installing the USB-4301

Unpacking the USB-4301

As with any electronic device, you should take care while handling to avoid damage from static

electricity. Before removing the USB-4301 from its packaging, ground yourself using a wrist strap or by simply

touching the computer chassis or other grounded object to eliminate any stored static charge.

If any components are missing or damaged, notify Measurement Computing Corporation immediately by

phone, fax, or e-mail:

 Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

 Fax: 508-946-9500 to the attention of Tech Support

Installing the software

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data

Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-

Quick-Start.pdf.

Installing the USB-4301

To connect the USB-4301 to your system, turn your computer on, and connect the USB cable to a USB port on

your computer or to an external USB hub that is connected to your computer. The USB cable provides power

and communication to the USB-4301.

The USB-4301 installs as a composite device with separate devices attached. When you connect the USB-4301

for the first time, Found New Hardware popup balloons (Windows XP) or dialogs (Windows 2000) display as

each USB-4301 interface is detected.

After the USB-4301 is installed, the Power LED remains lit to indicate that communication is established

between the USB-4301 and your computer.

Caution! Do not disconnect any device from the USB bus while the computer is communicating with the

USB-4301, or you may lose data and/or your ability to communicate with the USB-4301.

If the Power LED turns off

If the Power LED is illuminated but then turns off, the computer has lost communication with the USB-4301.

To restore communication, disconnect the USB cable from the computer, and then reconnect it. This should

restore communication, and the Power LED should turn back on.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Pas de commentaire

Measurement-computing USB-4301 Manuel d'utilisateur Page 10