Measurement-computing E-1608-OEM Manuel d'utilisateur télécharger pdf (Page 10)

E-1608-OEM User's Guide Installing the E-1608-OEM

Setting up the E-1608-OEM for communication across networks

In order to communicate with the E-1608-OEM from a computer connected to a different network – such as

over the Internet – you must change the network configuration of the network router.

In the following procedure, the E-1608-OEM is installed on the host LAN, and the computer is installed on the

client LAN.

Caution! This procedure should only be performed by a network administrator or computer professional.

Incorrect settings can significantly disrupt a network.

1. Assuming you have successfully connected to a local network, determine the IP address of the device. If

the address was assigned by DHCP, it is recommended you change it to a static address by setting the

default address to the address assigned and setting the device network configuration to static.

2. Configure the firewall/router to forward incoming traffic to the following ports to the IP address assigned

to the device:

o UDP:54211 (discovery)

o TCP:54211 (commands)

o TCP:54212 (scan data)

3. On the computer connected to the client LAN, manually enter the WAN address of the host router, and

specify the ports that were forwarded to connect to the remote E-1608-OEM.

If the ports listed above are not available on your router, you can use the following guidelines to select different

ports: The first port must be configured for both UDP and TCP. The second port must be adjacent to the first

and configured for TCP. For example, you could use 54221 (TCP and UDP) and 54222 (TCP).

Configuring network alarms

You can use software to configure any digital output bit and/or each analog output channel to generate specific

values to indicate when the device is connected and/or disconnected.

The settings can also be used to initialize an output to a specific value when the device connects or disconnects

from the network.

Restoring factory default network settings

To reset the network configuration settings to the factory default values, complete the following steps (refer to

Device components on page 12 for the location of this button):

1. Remove power from the device.

2. Press and hold the Factory reset button while re-applying power.

3. Hold the button for at least four seconds until both the Power and Activity LEDs blink, indicating that the

settings have been restored to the factory defaults.

4. Release the button so the device continues startup with the default settings. If the button is released before

the two LEDs blink, the settings are not affected and the device starts up normally.

If InstaCal is open when default settings are restored, click the Refresh Boards button on the InstaCal toolbar

to reflect the changes

Calibrating the hardware

The Measurement Computing Manufacturing Test department performs the initial factory calibration. Contact

Measurement Computing for details about how to return your device and have it calibrated to the factory

specifications. The recommended calibration interval is one year.

Field calibration is not supported.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Pas de commentaire

Measurement-computing E-1608-OEM Manuel d'utilisateur Page 10