Measurement-computing DBK60 Manuel d'utilisateur télécharger pdf (Page 4)

6 – Configure the chassis for the power source

Use one power source, and only one power source, for cards on the P1 bus!

+5 V is selected with the DBK60’s JP2 jumper, located inside the expansion chassis on the P1

interconnect board (see the following figure for location).

±15 V is selected with two JP1 jumpers, located on the board of the primary data

acquisition device, such as a DaqBook or ISA-type DaqBoard.

DO NOT CONFUSE THESE JP1 JUMPERS WITH THE JP1 JUMPER IN THE DBK60.

A. If +5 V will be supplied from a source

outside the expansion chassis, place a jumper on DBK60’s JP2

header. JP2 is located on the P1 interconnect board (see figure).

B. If +5 V will be supplied from

a DBK33 power card inside the expansion chassis, remove the jumper

from the JP2 header (located on the P1 interconnect board).

C. If using a DBK32A or DBK33 power card anywhere in the system, remove the +15 V and -15 V

jumpers from JP1 on the primary data acquisition device, such as a DaqBook or ISA-type

DaqBoard. DO NOT CONFUSE THESE JP1 JUMPERS WITH THE JP1 JUMPER IN THE DBK60.

Reference Notes:

Refer to the DBK32A or DBK33 sections, if applicable.

DBK60, pg. 4 989594 DBK Option Cards and Modules

1 2 3 4 5 6

Pas de commentaire

Measurement-computing DBK60 Manuel d'utilisateur Page 4